Denon AVR-1804 Operating Instructions Manual

Also see for AVR-1804: Specification sheet Operating instructions Operating instructions Service manual Operating instructions

17ENGLISHDENON and other makes of components can be operated by setting the preset memory.This remote control unit can be used to operate components of other manufacturers without using the learningfunction by registering the manufacturer of the component as shown on the List of Preset Codes (pages262~264).Operation is not possible for some models.Preset memory1 Set mode switch 1 to “AUDIO” or “VIDEO”.24 Referring to the included List of Preset Codes, use the number buttons to input thepreset code (a 3-digit number) for the manufacturer of the component whosesignals you want to store in the memory.1 2 34 5 67 8 905 To store the codes of another component in the memory, repeat steps 1 to 4.3214Set mode switch 2 to the component to beregistered.NOTES:• The signals for the pressed buttons are emitted while setting the preset memory. To avoid accidentaloperation, cover the remote control unit’s transmitting window while setting the preset memory.• Depending on the model and year of manufacture, this function cannot be used for some models, even ifthey are of makes listed on the included list of preset codes.• Some manufacturers use more than one type of remote control code. Refer to the included list of presetcodes to change the number and check.• The preset memory can be set for one component only among the following: CDR/MD, DVD/VDPand DBS/CABLE.The preset codes are as follows upon shipment from the factory and after resetting:TV, VCR......................................................................HITACHICD, TAPE ...................................................................DENONCDR/MD ....................................................................DENON (CDR)DVD/VDP ...................................................................DENON (DVD)DBS/CABLE ...............................................................ABC (CABLE)Set the AUDIO side for the CD, Tape deck orCDR/MD position, to the VIDEO side for theDVD/VDP, DBS/CABLE, VCR or TV position.3 Press the ON/SOURCE button and the OFFbutton at the same time.• Indicator flash.Operating component stored in the preset memory321333 Operate the component.• For details, refer to the component’s operating instructions.Some models cannot be operated with this remote control unit.1. Digital video disc player (DVD) system buttonsPOWER : Power on/standby(ON/SOURCE)OFF : DENON DVD Poweroff6, 7 : Manual search(forward and reverse)2 : Stop1 : Play8, 9 : Auto search(to beginning of track)3 : Pause0 ~ 9, +10 : 10 keyDISC SKIP : Disc skip+ (for DVD changer only)DISPLAY : Switch displayMENU : MenuRETURN : ReturnSETUP : SetupD, H, F, G : Cursor up, down, leftand rightENTER : Enter setting1 Set mode switch 1 to “AUDIO” or “VIDEO”.2 Set mode switch 2 to the component you wantto operate.Set the AUDIO side for the CD, tape deck orCDR/MD position, to the VIDEO side for theDVD/VDP, DBS/CABLE, VCR or TV position.2. Video disc player (VDP) system buttonsPOWER : Power on/standby(ON/SOURCE)6, 7 : Manual search(forward and reverse)2 : Stop1 : Play8, 9 : Auto search (cue)3 : Pause0~9, +10 : 10 keyNOTE:• Some manufacturers use different names forthe DVD remote control buttons, so also refer tothe instructions on remote control for thatcomponent.