Denon AVR-1804 Operating Instructions Manual

Also see for AVR-1804: Specification sheet Operating instructions Operating instructions Service manual Operating instructions

2313 SURROUNDBefore playing with the surround function• Before playing with the surround function, be sure to use the test tones to adjust the playback level from thedifferent speakers. This adjustment can be performed with the system setup (see page 11) or from the remotecontrol unit, as described below.• Adjusting with the remote control unit using the test tones is only possible in the “Auto” mode and onlyeffective in the DOLBY/DTS SURROUND modes. The adjusted levels for the different modes are automaticallystored in the memory.12 Press the TEST TONE button.Test tones are output fromthe different speakers. Usethe channel volume adjustbuttons to adjust so thatthe volume of the testtones is the same for allthe speakers.4 After completing theadjustment, press theTEST TONE button again.1 Set the DOLBY/DTS SURROUND (Dolby ProLogic II or Dolby Digital or DTS) modes.(Main unit) (Remote control unit)32, 431• After adjusting using the test tones, adjust the channel levels either according to the playback sources or tosuit your tastes, as (described) below.FL CNTR FR SR SBSW SL1 Select the speaker whoselevel you want to adjust.2The channel switches as shown below eachtime the button is pressed.Adjust the level of theselected speaker.(Remote control unit)NOTE:• Please make sure the “AUDIO” position ofthe slide switch on the remote control unit.212Default setting of channel level is 0 dB.The level of the selected speaker can beadjusted within the range of +12 to –12 dBusing the cursor buttons.SW channel level can be turned off bydecreasing one step from -12 dB.OFF ´ -12 dB ´ 12 dB(Remote control unit)(Remote control unit)3(Remote control unit)ENGLISHNOTE:• Please make sure the “AUDIO” position ofthe slide switch on the remote control unit.