11Connecting an antennatConnect the FM antenna or AM loop antenna supplied with the unitto enjoy listening to radio broadcasts.tAfter connecting the antenna and receiving a broadcast signal(vpage 27 “Listening to FM/AM broadcasts”), fix the antennawith tape in a position where the noise level becomes minimal.w eqFM outdoorantennaDirection of broadcasting station75 Ω coaxialcableGroundAM outdoorantennaAM loop antenna(supplied)BlackWhite FM indoorantenna(supplied)n AM loop antenna assembly1 Put the stand sectionthrough the bottom of theloop antenna from therear and bend it forward.StandSquareholeProjectingpartLoopantenna2 Insert the projecting partinto the square hole inthe stand.n Using the AM loop antennaSuspending on a wallSuspend directly on a wall without assembling.Nail, tack, etc.Standing aloneUse the procedure shown above to assemble.NOTEtDo not connect two FM antennas simultaneously.tEven if an external AM antenna is used, do not disconnect the AMloop antenna.tMake sure the AM loop antenna lead terminals do not touch metalparts of the panel.tIf the signal has noise interference, connect the ground terminal(GND) to reduce noise.tIf you are unable to receive a good broadcast signal, we recommendinstalling an outdoor antenna. For details, inquire at the retail storewhere you purchased the unit.Connecting a CD playertYou can enjoy CD sound.tSelect the connector to use and connect the device.Cables used for connectionsAudio cable (sold separately)Audio cable RLRLRLRLAUDIOAUDIORLOUTCD playerSet this to change the digital input connector to which the inputsource is assigned.“Input Assign” (vpage 101)in Set as NecessaryBasic version Advanced version InformationBasic version