Denon AVR-2112CI Owner's Manual

Also see for AVR-2112CI: Service manual Getting started Specification sheet Owner's manual Getting started

Contents

59Set up speakers7 Set up “Channel Select”Use ui to select “Channel Select”, and then pressENTER.Subwoofer MeasureChannel Select[RETURN] ReturnMultEQ XTPreparationSet the following itemsif necessary.Amp AssignChannel SelectAudyssey Auto SetupAuto Setup Start[RETURN][ENTER] Enter Cancel8 Use ui to select a channel.Front Select for setting the front speakers to be used. In thiscase, go to step 9.t“Front” can be set when “Amp Assign” is set to“Front B”.Subwoofer Select for no subwoofer to be used. In this case, goto step 10.SurroundBackSelect the number of surround back speakers to beused. In this case, go to step 11.t“Surround Back” can be set when “Amp Assign” isset to “NORMAL”.9 Press o p to select a front speaker.A Select this to use front speaker A.B Select this to use front speaker B.A+B Select this to use front speakers A and B simultaneously.10 Use o p to set whether or not a subwoofer channelis measured.Measure Set for measuring a subwoofer.Skip Set for no measuring of a subwoofer.11 Use o p to set whether or not a surround backchannel is measured.Measure(2 sp) Set for measuring two surround back speakers.Measure(1 sp) Set for measuring a surround back speaker.Skip Set for no measuring of a surround back speaker.12 Press RETURN B.Proceed to page 16 STEP1 Preparation step 6.NOTEAfter performing Audyssey® Auto Setup, do not change the speakerconnections or subwoofer volume. In event of a change, performAudyssey® Auto Setup again.5 Use o p to select the ' speakers.NORMAL Select the “NORMAL” setting to perform7.1-channel playback using the surround backspeakers.ZONE2 Select the “ZONE2” setting to assign the unit’sbuilt-in power amplifier for ZONE2 and output theaudio in stereo.Bi-AMP Select the “Bi-AMP” setting to connect the frontspeakers via the bi-amp connection.Front B Select the “Front B” setting to use the second setof front speakers for playback.F.HEIGHT Select the “F.HEIGHT” setting to use the frontheight speaker for playback.6 Press RETURN B to exit the “Amp Assign” setting.Basic version Advanced version InformationAdvanced version