Denon AVR-2310CI Owner's Manual

Also see for AVR2310CI - Multi-Zone Home Theater Receiver: Specification Service manual Capabilites and Compatibilities Getting started guide Product sheet

ENGLISHGetting Started Connections Remote Control Information Troubleshooting SpecificationsMulti-ZoneSettings1 Press to select “SIRIUS”.2 Press on the main unit until “SIGNAL” appearson the display.The display will switch as shown below,depending on the reception conditions.Display StatusEXCELLENT Signal strength is excellentGOOD Signal strength is goodWEAK Signal strength is weakNO SIGNAL No signal3 Adjust the position of the antenna until “SIGNAL:EXCELLENT” is shown on the display.4 Press on the main unit until the channel youwant to check (example: “SR001”) is displayed.5 Press and select channel 0 (SR000).Channel No. and Sirius ID are alternatelyshown on the display.SR000 SiriusID************b Write your own SIRIUS ID for storage use.Sirius ID :• The channel switches continuously whenis pressed and held.• The song title, artist name, composer name,category and reception level can be checkedby pressing on the main unit.• The time (default : 30 sec) for which the on-screen display are displayed can be set atmenu “GUI-Tuner” (vpage 34).Press uio p to return to the original screen.FrontThe strength of both the SIRIUS and terrestrial signals can be checkedat menu “Antenna Aiming” (vpage 41).Playing ComponentsChecking the SIRIUS Signal Strength and Radio IDFront1 Press to select the memory block (A to G).2 Press to select the desired preset channel (1to 8).1 Tune in the broadcast channel you want to preset.2 Press .3 Press to select the block (Ato G) in which the channel is to bepreset.4 Press to select the preset number (1 to 8).5 Press again to complete the setting.To preset other channels, repeat steps 1 to 5.NOTEPreset channels are erased by overwriting them.Presetting Radio Channels (Preset Memory)�our favorite broadcast channels can be preset so that you can tunethem in easily. Up to 56 channels can be preset.Listening to Preset ChannelsFront1 Press o p.SR001 Hits 1CAT : Pops2 Use o p to select the category,then use ui to select the desiredchannel.Channel category• “UPDATING” is displayed while the encoding code is beingupdated.• “SIRIUS UPDATING” is displayed when updating SIRIUS tunerfirmware.• Refer to “Troubleshooting” – “SIRIUS Satellite Radio” regarding othermessages (vpage 69).Searching CategoriesFrontPlaybackSirius IDFront1 Tune to the channel you want to lock.2 Press for at least 3 seconds.“Code: [ ]” is displayed.3 Enter the 4-digit lock code usinguio p.When you enter the correct code, the corresponding channel islocked.4 Press .• Channels under Parental Lock cannot be tuned in by performingTuning Up/Down or by category search.• Channels stored in preset memory can be tuned in by the presetchannel select operation, even if Parental Lock is applied.• When a channel to which Parental Lock is applied is being played,Parental Lock for that channel is cancelled by performing Step2.• See “Edit Lock Code” (vpage 41) for the method of changingParental Lock Code.• �ou can also set “Parental Lock” from the menu (vpage 41).Parental LockFront