Denon AVR-3806 Operating Instructions Manual

Also see for AVR-3806: Operating instructions Capabilities and Compatibilities Guide Specifications Supplementary guide Code List

Contents

40Basic Operation Basic OperationPress the CURSOR FF or GG button to set the level.To increase the bass or treble:The bass or treble sound can be increased up to +6 dB insteps of 1 dB.To decrease the bass or treble:The bass or treble sound can be decreased down to –6 dBin steps of 1 dB.7 Press the ENTER button.• The surround parameter menu screen reappears.8 Press the ENTER or SURROUND PARAMETERbutton to complete the setting.46Press the CURSOR GG button to select “ToneDefeat OFF”.5 Press the CURSOR DD or HH button to select“Bass” or “Treble”.2 Tone defeat modeIf you do not want the bass and treble to be adjusted, turn on thetone defeat mode.Press the TONE DEFEAT button to turn on “ToneDefeat” mode.The signals do not pass through the bass and trebleadjustment circuits, providing higher quality sound.Channel levelYou can adjust the channel level either according to the playbacksources or to suit your tastes, as described below.1 Press the ENTER button.• The “Channel Vol.” screen is displayed.2Channels which is not used are not displayed.Press the CURSOR DD, HH or ENTER button toselect the speaker.The channel switches as shown below each time the ENTERbutton is pressed.3 Press the CURSOR FF or GG button to adjust thelevel.The adjustment range for the different channels is +12 dBto –12 dB in step of 0.5 dB.The sound from the subwoofer can be completely cut bylowering the SW (subwoofer) setting one additional from–12 dB (setting it to “OFF”).FADERSRSBLSL SBRFL C FR SWFader functionThis function makes it possible to lower the volume of the frontchannels (FL, C and FR) or the rear channels (SL, SR, SBL andSBR) together. Use it for example to adjust the balance of thesound from each position when multi-channel music sources areplayed.1 Press the ENTER button.• The “Channel Vol.” screen is displayed.2 Press the CURSOR DD, HH or ENTER button, thenselect “Fader”.The channel switches in the order shown below each timethe ENTER button is pressed.FADERSRSBLSL SBRFL C FR SW• When the surround back speaker setting is set to “1spkr” for“Speaker Configuration” ( page 73), this is set to “SB”.• The channel whose channel level is adjusted lowest can befaded to –12 dB using the fader function.• If the channel levels are adjusted separately after adjusting thefader, the fader adjustment values are cleared, so adjust thefader again.3 Press the CURSOR FF button to reduce thevolume of the front channels, the CURSOR GGbutton to reduce the volume of the rear channels.Example: When “FRONT” is selectedThe fader function does not affect the subwoofer channel.ENGLISHENGLISH