Denon AVR-786 Operating Instructions Manual

Also see for AVR-786: Service manual Operating instructions Brochure & specs

Contents

Easy Setup and OperationPOWERON/STANDBYSPEAKERASETUP MICON/SOURCEMODE 1-,,_J..... ; ENTERSETUP- _!__ CURSOR°__SPEAKERThe Auto Setup function of this unit performs an analysis of thespeaker system to permit an appropriate automatic setting.Connect the microphone for Auto Setup to the• Measurement and setting details / SETUP MIC jack on the front panel of the unit.'L:This sets tile speaker connection, polarity, and bassreproduction ability. _ _ _ " _ _ _' _ _ _ _ _ _ _ t1,: This sets the delay time from each speaker corresponding to © _ o _ ° o o o othe listening position.'3;: This sets the volume that is output from each speaker.For accurate measurements• Keep quiet during the auto setup procedure, it is recommendedthat you turn off the power of any air-conditioner, projector orother equipment that may produce noise.• Do not stand between the microphone and speakers whileAuto Setup is performed.• Do not place any obstacles between the microphone andspeakers. Also, be sure to point the speakers tewards thelistening position.NOTE:• A loud test tene is output during the measurement. Pleaseconsider this should you be planning night timemeasurements, and consider not allowing small childreninto the listening reem at this time.©Place the microphone for Auto Setup at theactual listening position which will be at thesame height as your ears.•_ Place zne mlcroenone on a tnooa or level surface.Easy Setup and OperationTurn on your subwoofel:Turn on your monitor (TV).Press the POWER switch.ON:T_-e oovv'er Turns on anti the inolcaTor lighTS.Set the POWERs _vltcn to tnls ooslt an to Turn Tne oower )nana off from the included remote comro UnIT1 OFF:The Dower turns oft ana tne namator is off.mls oosmon. _ne Dower cannot De Turnea on ana off fromtne remote ConTrol unllPress the ON/STANDBY switch on the main unitor ON/SOURCE button on the remote conn-olunit.'* TU[II Oli [[le 3owelPress the SPEAKERA button to turn the speakerson.Set the MODE 1 switch to "AUDIO" (only whenoperating with the remote control unit).8I ENGLISH I