Denon AVR-786 Operating Instructions Manual

Also see for AVR-786: Service manual Operating instructions Brochure & specs

Contents

Advanced Operation Advanced OperationFUNCTION ZONE2/RECSELECTPOWER SPEAKERIf the indication on the display is not normal or if the operation ofthe unit is not correct, then the microprocessor should be resetby the following procedure.Switch off th e unit using the main unit!sPOWER Switch.Keep both SPEAKER A and B button s depressedand turn on the unit by pressing the main unit,sPOWER Switcka_ Chec k that the entire display is flashing at !:second inter_als and release the buttons.• Tile microprocessor will be initialized:Press the ZONE2/REC SELECTbutton to displaythe "RECOUT SOURCE" on the display.'_ The disola_ swltcnes as follows each time me Dultor s0ressea.ZONE2 RECTurn the FUNCTION knob to select the sourceyou want to output appears on the display.Set the recording mode.• This unit is equipped with a last function memory which storesthe input and output setting conditions as they wereimmediately before the power is switched off.This function eliminates the need to perform complicatedresettings when the power is switched on.• The unit is also equipped with a back-up memory. This functionprovides approximately one week of memory storage when themain unit's POWER switch is off and the power supply corddisconnected.• if step 3 does not work, start over from step 1.• If the microprocessor has been reset, all the button settings arereset to the default values (the values set upon shipment fromthe factory).'_ Y-OI operating 9sTrucTIQnS refer to the manual o _ mecor'nDoneni on wnlcn yOU ',A/anT TO recora÷ To cance turn the FUNCTION knob and select "SOURCE".• Recording sources other than digital inputs selected in the RECOUT mode are also output to the ZONE2 audio outputterminals.• Digital signals are net output to the REC SOURCE or audiooutput terminals.• The DIGITAL IN's signal selected with the FUNCTION knob isoutput to the DIGITAL OUT (OPTICAL) terminal.37I ENGLISH I