Denon AVR-786 Operating Instructions Manual

Also see for AVR-786: Service manual Operating instructions Brochure & specs

Contents

Basic OperationINPUT MODEFUNCTION J ANALOG MASTER VOLUMEMAIN EXT.IN / SELECTSURROUND MODEt elect the input source to be played.Example: CDFUNCT o_ C0Mair Urlli Remote eonirol unli÷ To seJect me InPut source when ZONE2iREC OUT is selectedDress me MAIN DUIIOn men operate me InDul functiorselectorSelect the play (surround) mode.Example: STEREO(Main ur t_ qemote control unit)'_ To se eCT the Burrouna moae While aajuSl_lng [Re surrouna9arameters. tone aeTeat ortone contro Dress tra SURROUNDMODE button and tnen ooerate me selectorFUNCTION-INPUT MODE-1 2 3:© (b-SURROUNDMODE-VOLUME-MUTING-EXT.IN-ANALOG"_ For operaTing insTrucTions, refer to me comDonem s manual.Adjust the volume.:ov vesmaster volume levelMain unit Remote control unit alselav."_ The volume can De aa usTea wlmln me range of -70 to 0 to18 dB. in sIeDs of 1 dB. Howeve[: wnen me cnannel BevelisSeT as ]escraec (_aage 28). if the volume for an.cnanneJ is set at + JB or greater, me volume cannot Deaajustea up to 18 dB n thiS case me rc_xlmum VOlume isae usted to "18 dB Maximum value of channe leve ._Basic OperationThe signals being input tD the external decoder input terminalsare played without passing through the surround circuitry.Press the EXT. IN button to Select the external input.• Canceling the external input mode:Press the INPUT MODE or ANALOG button to switch to thedesired input mode (_ page 19, 20).• The external input mode can be set for any input source. Towatch video while listening to sound, select the input source towhich the video signal is connected, then set this mode.• If the subwoofer output level is too high, set the "SW ATT."surround parameter to "ON".NOTE:• When the input mode is set to the external input (EXT. IN),the play mode (DIRECT, VIRTUAL SURROUND, STEREO,STANDARD DOLB_ DTS SURROUND), 5CH/7CH STEREOor DSP SIMULATIOI cannot be selected.• _" Dlav modes mer man the external input mode, theslgnaas connectea r me EXT. IN terminals cannot be_[ OtJUt._J _t-I_Jl[lOII, 5i_lldlb bdllllut b_ uutput fluIllcnannels not connectea to the input terminals.use mls to turn off the audio output temporarily.Press the MUTING button.• Youcan ad ust me r'nutlng level ( X2_page 43),• Canceling the MUTING x]oae1 Press the MUTING DUIton again,2 Press me VOLUME Duncan on the remote control unit, oraa Jst me lume UD or down via the front panel MASTERVOLUME knob18I ENGLISH I