Denon AVR-890 Owner's Manual

Also see for AVR-890: Specifications Specification Service manual Comparison chart Getting started guide

Getting Started Playback Remote Control Information Troubleshooting SpecificationsENGLISHMulti-ZoneSettingsConnecting Devices not Equipped with HDMI terminalsSIRIUSConnect Home TunerSIRIUS Connector• The AVR-890 is a SIRIUS Satellite Radio Ready® receiver. You can receive SIRIUS® Satellite Radio byconnecting to the SiriusConnect Home Tuner and subscribing to the SIRIUS service.• Plug the SIRIUS connector on the rear panel.• Position the Home Tuner antenna near a south-facing window to receive the best signal.For details, see “Listening to SIRIUS Satellite Radio Programs” (vpage 42, 43).When making connections, also refer to the operating instructions of the SiriusConnect Home Tuner.NOTEKeep the power cord unplugged until the SiriusConnect Home Tuner connection have been completed.“SIRIUS, XM and all related marks and logos are trademarks of Sirius XM Radio Inc. and its subsidiaries.All rights reserved. Service not available in Alaska and Hawaii.”n Positioning the AntennaFor a consistent satellite signal, the antenna must be positioned correctly. Use the following map todetermine which area you are in and position the antenna accordingly.qw ertSOUTHNORTHWESTSKYEASTHORIZONArea 1 : Point the antenna toward the sky in the east,northeast, or southeast, either through awindow or outside.Area 2 : Point the antenna toward the sky in the northor northeast, either through a window oroutside.Area 3 : Point the antenna toward the sky in the northor northwest, either through a window oroutside.Area 4 : Point the antenna toward the sky in the west,northwest, or southwest, either through awindow or outside.Area 5 : Put the antenna outside and point it straightup. The antenna cannot be used indoors.b When connectingdigital audioDirection of broadcasting stationAM loopantenna(supplied)FM antenna75 Ω/ohmsCoaxial cableFM indoor antenna(supplied)GroundAM outdoor antennaAntenna terminalsn AM loop antenna assembly1 Remove the vinyl tie and takeout the connection line.2 Bend in the reverse direction.3 With the antennaon top of anystable surface.3 With the antennaattached to a wall.-1-2MountInstallation hole Mount on wall, etc.1 Push the lever.2 Insert the conductor.3 Return the lever.n Connection of AM antennasNOTE• Do not connect two FM antennassimultaneously.• Even if an external AM antenna is used, do notdisconnect the AM loop antenna.• Make sure the AM loop antenna lead terminals donot touch metal parts of the panel.Set this to change the input signal to which the inputsource is assigned.“Input Assign” (vpage 35)Set as necessaryConnections