Denon AVR-890 Owner's Manual

Also see for AVR-890: Specifications Specification Service manual Comparison chart Getting started guide

Getting Started Connections Playback Remote Control Information Troubleshooting SpecificationsENGLISHMulti-ZoneMaking detailed settings (Manual Setup)Setting items Setting contentsQuick Select NameChange the Quick Selectname.Rename Label : Change the display name of the selected “Quick Select”setting.1. Use ui to select the name of the Quick Select setting you wantto change, then press .2. Use o p to set the cursor to the character you want to change.3. Use ui to change the character, then press .• Up to 16 characters can be input.• The input character type can be switched by pressing while thedisplay name is being changed.• The types of characters that can be input are as shown below.GUpper case charactersH ABCDEFGHIJKLMNOPQRSTUVWXYZGLower case charactersH abcdefghijklmnopqrstuvwxyzGSymbolsH ! “ # $ % & ‘ ( ) * + , - . / : ; < = > ? @ [ \ ] ^ _ ` { | } ˜GNumbersH 0123456789 (Space)4. Repeat steps 2 and 3 to change the display name.Zone RenameRename the display namesof the different zones asdesired.1. Use ui to select the zone name you want to change, then press.MAIN ZONE / ZONE22. Use o p to set the cursor to the character you want to change.3. Use ui to change the character, then press .• Up to 10 characters can be input.• The input character type can be switched by pressing while thedisplay name is being changed.• The types of characters that can be input are as shown below.GUpper case charactersH ABCDEFGHIJKLMNOPQRSTUVWXYZGLower case charactersH abcdefghijklmnopqrstuvwxyzGSymbolsH ! “ # $ % & ‘ ( ) * + , - . / : ; < = > ? @ [ \ ] ^ _ ` { | } ˜GNumbersH 0123456789 (Space)4. Repeat steps 2 and 3 to change the display name.: Moves the cursor (Up/Down/Left/Right) : Decision the setting : Return to previous menuRemote controloperation buttons : Displaying the menuCancel the menuSetting items Setting contentsRemote IDSet when you operateanother DENON AV amplifierwith the remote control unitof the AVR-890. Match theremote control unit you areusing with the remote ID ofthe AVR-890.1 / 2 / 3 / 4When using the AVR-890 with only the included remote control unit(RC-1117), use Remote ID “1” (default).When using a separately sold remote control unit (RC-7000CI, etc.),this function can be used. Match the ID setting of the remote controlunit and the receiver.DimmerAdjust display brightness ofthe receiver.Bright : Normal display brightness.Dim : Reduced display brightness.Dark : Very low display brightness.OFF : Turns the display off.Switching is also possible by pressing on the main unit.••••Setup LockProtect settings frominadvertent change.ON : Turn protection on.OFF : Turn protection off.When “Setup Lock” is set to “ON”, the settings listed below canno longer be changed. Also, “SETUP LOCKED!” is displayed if youattempt to operate related settings.・RESTORER ・Dynamic Volume・MultEQ ・Channel Level・Dynamic EQ ・Audio Delay••Settings