148AppendixTipsPlaybackConnectionsContentsFront panel Display Rear panel IndexRemoteSettingsBassSet subwoofer and LFE signal range playback.2 Subwoofer ModeSelect low range signals to be reproduced by subwoofer.LFE (Default) : The low range signal of the channel set to “Small”speaker size is added to the LFE signal output from thesubwoofer.LFE+Main : The low range signal of all channels is added to the LFEsignal output from the subwoofer. This is usually the bestsetting for most systems.%• “Subwoofer Mode” can be set when “Speaker Config.” – “Subwoofer”(vpage 145) is set to other than “No”.• Play music or a movie source and select the mode offering the strongestbass.• If “Front” and “Center” for “Speaker Config.” (vpage 145) are set to“Large”, and “Subwoofer Mode” is set to “LFE”, no sound may be outputfrom the subwoofers, depending on the input signal or selected sound mode.Select “LFE+Main” if you want the bass signals to always be produced fromthe subwoofer.2 LPF for LFESet LFE signal playback range. Set this when you want to change theplayback frequency (low pass filter point) of the subwoofer.80Hz / 90Hz / 100Hz / 110Hz / 120Hz (Default) / 150Hz / 200Hz / 250Hz
