149AppendixTipsPlaybackConnectionsContentsFront panel Display Rear panel IndexRemoteSettingsInput SelectSet the audio input mode and decode mode of each input source.The input modes available for selection may vary depending on the inputsource.2 Input ModeSet the audio input modes for the different input sources.It is normally recommended to set the audio input mode to “Auto”.Auto (Default) : Automatically detect input signal and perform playback.HDMI : Play only signals from HDMI input.Digital : Play only signals from digital audio input.Analog : Play only signals from analog audio input.%• When digital signals are properly input, the ~ indicator lights on the display.If the ~ indicator does not light, check “Input Assign” (vpage 146) andthe connections.• If “HDMI Control” is set to “On” and a TV compatible with the ARC isconnected via the HDMI MONITOR connectors, the input mode whose inputsource is “TV AUDIO” is fixed to ARC.2 Decode ModeSet the audio decode mode for input source.Auto (Default) : Detect type of digital audio input signal and decode andplay automatically.PCM : Decode and play only PCM input signals.DTS : Decode and play only DTS input signals.%• This item can be set for input sources for which “HDMI” or “DIGITAL” isassigned at “Input Assign” (vpage 146).• Normally set this mode to “Auto”. It is recommended to set “PCM” or “DTS”when audio is missing at the beginning or a noise occurs.
