165AppendixTipsPlaybackConnectionsContentsFront panel Display Rear panel IndexRemoteSettingsNetworkTo use this unit by connecting it to a home network (LAN), you must configure network settings.If you set up your home network (LAN) via DHCP, set “DHCP” to “On” (use the default setting). This allows this unit to use your home network (LAN).When assigning an IP address to each device manually, you need to assign an IP address to this unit using the “IP Address” settings, and enterinformation about your home network (LAN) such as the gateway address and subnet mask, etc.InformationDisplay network information.Friendly Name / DHCP On or Off / IP Address / MAC Address%• MAC Address is required to make a vTuner account.IP ControlEnables network communication in standby power mode.Off In Standby (Default) : Suspend network function during standby.Always On : Network is on during standby. Main unit operable with anetwork compatible controller.%• When using the web control function or Denon Remote App, use with the “IPControl” setting set to “Always On”.NOTE• When “IP Control” is set to “Always On”, it consumes more standby power.Friendly NameThe Friendly Name is the name of this unit displayed on the network. Youcan change the Friendly Name according to your preferences.2 Edit NameEdits Friendly Name.%• The default Friendly Name on first use is “Denon AVR-X3000”.• Up to 63 characters can be input.• For character input, see page 129.2 Set DefaultsRestores Friendly Name, which you had changed, to the default setting.
