5 Select “Start”, then press ENTER.Audyssey® Setup can also make the following settings.0 Amp AssignThe signals output from the SURROUND BACK speakerterminals can be switched in accordance with your speakerenvironment. (“Amp Assign” (v p. 178))0 Channel SelectIf channels that are not to be used are set in advance,measurement for the set channels is skipped, and measuringtime can be reduced. You can also change the number ofsurround back speakers.0 Dolby Sp.SetupSet the distance between the Dolby Atmos Enabled speaker andthe ceiling.This can be set when “Assign Mode” is set to “Front Dolby” or“Surround Dolby” in the “Amp Assign” settings. (v p. 178)6 Follow the instructions on the screen display and press“Next” to proceed further.7 When the following screen is displayed, select “BeginTest” and then press ENTER.Start the measurement of the first position. .Select “Begin Test” to Start the Calibration.NOTE:You will hear a series of loud test tonesstarting and stopping during the tests.Begin TestBackAudyssey SetupEar Height0 Measurement requires several minutes.NOTE0 If “Caution!” is displayed on TV screen:0 Go to “Error messages” (v p. 176). Check any related items, andperform the necessary procedures.Contents Connections Playback Settings Tips Appendix171Front panel Display Rear panel Remote Index
