Wireless LANWhen connecting to a wireless LAN network, stand the rod antenna forBluetooth/wireless LAN connection upright on the rear panel.See “Wi-Fi Setup” on how to connect to a wireless LAN router.(v p. 189) .InternetModemTo WAN sideRouter with access point0 When using this unit, we recommend you use a router equipped with the followingfunctions:0 Built-in DHCP serverThis function automatically assigns IP addresses on the LAN.0 Built-in 100BASE-TX switchWhen connecting multiple devices, we recommend a switching hub with aspeed of 100 Mbps or greater.0 Only use a shielded STP or ScTP LAN cable (readily available at electronicsstores). (CAT-5 or greater recommended)0 The normal shielded-type LAN cable is recommended.If a flat-type cable or unshielded-type cable is used, other devices could beaffected by noise.0 When using a router that supports the WPS (Wi-Fi Protected Setup) function, Wi-Fi connection can be carried out easily.0 When using this unit connected to a network with no DHCP function, configure theIP address, etc. in “Network”. (v p. 188)NOTE0 The types of routers that can be used depend on the ISP. Contact your ISP or acomputer shop for details.0 This unit is not compatible with PPPoE. A PPPoE compatible router is required ifyour contracted line is not set using PPPoE.0 Do not connect a NETWORK connector directly to the LAN port / Ethernetconnector on your computer.0 Various online services may be discontinued without prior notice.Contents Connections Playback Settings Tips Appendix58Front panel Display Rear panel Remote Index
