Dension Lite BT Manual For Installation

Also see for Lite BT: User guide User manual General user guide

Contents

Dension Lite BT Manual For Installation Manual pdf 10 page image

Troubleshooting Guide for Installing Dension Products10K. iPod/iPhone not recognizedThis usually happens if there is a problem with the iPod / iPhone or Dock cable. Before replacinganything, you need to try the following: Make sure there is music on the Apple device Reboot the Apple device (if it is an iPhone, close all apps before rebooting) Update the iPod/iPhone if a newer iOS version is available Check the charging status. If there is no charging the problem might be installation related(no ground cable connected on VW/Audi) Test the system with a different Apple product Disconnect and reconnect the Gateway hardware from the power Check the Dension website. There might be an available update for the GatewayL. USB compatibilityFlash Memory and Hard Disk DrivesFile system: FAT32Storage capacity: up to 256 GB of music contentMusic format: MP3 MPEG1 Layer 3 : 32; 44,1; 48 kHz (32 - 320kbps); MPEG2 Layer 3 : 16; 22,05; 24 kHz (8 - 160kbps); MPEG2.5 Layer 3 : 8; 11.025; 12 kHz (8 -160 kbps) from 96 kb/s to 320 kb/s; MP3 Variable Bit Rate (VBR) (up to 320kb/s). WMA 4 - 44.1 kHz at sample rates up to 320 kb/s. Except for DRM protected files. WAV (16 bit, uncompressed PCM)We recommend the use of branded USB drives (TDK, Kingston, Sandisk, Transcend etc.).M. USB does not work/Gateway does not see the connected device:In some cases the USB drive will only flash continuously or flash just once (if there is a status indicatorLED on it) but will not play audio. When USB is connected to Gateway, it starts to index the contentimmediately (LED on the USB is flashing constantly) in order to find and select the tracks as quickly aspossible. If a large music content is available (4GB or above) it may take a few minutes during whichthe drive cannot be accessed, so playback might not be available, or when the user changes the musiccontent on the USB the Gateway might not find the previously indexed songs.So, if there is a problem with the USB playback, do the following:- wait for a few minutes, then the playback should start- turn the system OFF, remove the key from the ignition, wait for 2 minutes, and turn thesystem back ON – the playback should start immediately- delete all ‘.bin’ files from the root folder of the USB drive (the index files might be damaged)- download the ‘Gateway Indexer software’ (Windows only) from our website. It indexes themusic files same way as the Gateway, but faster