Chapter 2 Getting Started the BHT and System Mode91[5.9] Testing with PINGOn the TEST menu, selecting "9: PING" calls up the screen shown atleft.[1] RUN PING: Runs PING.[2] SET PING: Switches to the PING parameter setting screen.[3] SET DEVICE: Switches to the PING device setting screen.Select a desired item by using the numerical keys or F5 and F6 keys,and then press the ENT key.To return to the TEST menu, press the C key.(1) PING screen⇓On the TEST PING menu, select "1: RUN PING" to call up the screenshown at left where the current settings are displayed.The COUNT entry box enclosed with brackets is ready to accept data.If you want to modify the number of echo requests displayed, enterthe desired value by using the numerical keys.To delete a single character, press the BS key. To delete the wholeentry you made, press the C key.Press the ENT key to start PING.(PING running screen)(PING end screen)Once PING starts running, the message shown at left appears.To stop PING, press the C key.The PING result may include the following:OK: Displays the number of echo replies.[XXXXX]: Echo reply time in millisecondsNG: Displays the number of errors found during execution ofPING.TIMEOUT: Displays the number of timeouts (for echo replies) thattook place during execution of PING.IP: Displays the BHT's IP address during execution ofPING only.
