Desa CGEFP33PR Owner's Operation And Installation Manual

Also see for Comfort Glow CGEFP33NR: OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL

Contents

www.desatech.com 108117-01K12Mounting Wall Switch to Side of Mantel7. Create three openings in the mantel wall ac-cording to Template 2, page 39. This is bestdone by making a pattern to work with on themantel. Carefully cut page 41/42 from manualand tape paper template vertically onto man-tel wall at preferred location. Pierce the paperat the centers of the 2 holes with a nail or sharppencil, leaving a mark on the wall. Do thesame at centers of the four circles near the cor-ners of the rectangle.8. Remove paper template from mantel wall.9. Drill 1/8" pilot holes at each mark for top andbottom screw holes. Drill 3/8" holes at eachmark for centers of four circles near cornersof rectangle.10. Using a straight edge and pencil, connect theouter edges of the 4 holes for the rectangle(see Figure 10, page 11). This will give youcutting lines for the rectangle you will cut inthe mantel wall.11. Using a keyhole saw, hack saw blade, drill, file,or other suitable tool, carefully cut out the rect-angular opening.Note: The corners of the rect-angle may be round.IMPORTANT: Do not ex-ceed the size of the rectangle on template.12. Carefully pass switch/plate assembly throughrectangular opening from inside mantel (seeFigure 13, page 11).13. Position switch/plate assembly vertically overopening with decal lettering upright. Makesure wires freely pass through wall withoutbinding. Align holes in wall plate with 1/8"pilot holes in mantel wall.14. Drive mounting screws, removed in step 2 ofRelocating Wall Switch on page 10, through wallplate holes and into pilot holes in mantel wall.15. Tighten screws until wall plate is firmly at-tached to mantel. Do not overtighten.INSTALLING VARIABLE SPEEDBLOWER ACCESSORYNOTICE: Shut off gas supplyand disconnect heater from gassupply if installing blower intopreviously installed fireplace.Contact a qualified service per-son to do this.INSTALLATIONContinued1. If fireplace screen and floor are still installed,see Removing Fireplace Screen and FloorAssembly, page 9.2. Attach the power cord to the blower motor byfirmly pushing the two female terminals at theend of the power cord onto the two spade ter-minals on the blower motor.3. Attach green ground wire from power cord toblower housing using screw provided (see Fig-ure 14). Tighten screws securely.4. Place the blower against lower rear wall offirebox outer wrapper with the exhaust portdirected upward. Align the holes in top mount-ing tabs of blower with holes in wall of wrap-per (see Figure 14). Using 2 screws provided,mount blower and tighten screws securely.5. Be certain that all wire terminals are securelyattached to terminals on blower motor and thatthe screw retaining the green ground wire is tight.6. Place control knob provided on plastic con-trol shaft of speed control.7. Mount the speed control on the front leg ofthe left floor support bracket using 2 screwsprovided (see Figure 15).Figure 14 - Mounting Blower to FireboxLower RearWall ofFireboxBlowerTopMountingTabExhaustPortScrewGreen Ground WireScrewsFigure 15 - Attaching Speed Control toFireboxScrewsSpeedControlControlKnobLeft FloorSupportBracketControlShaft