Desa CGEFP33PR Owner's Operation And Installation Manual

Also see for Comfort Glow CGEFP33NR: OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL

Contents

www.desatech.com108117-01K 27OPERATING FIREPLACEContinuedAutomaticIgnitorElectrodePilotBurnerFigure 52 - Pilot (Natural Gas)Manual IgnitorElectrodeFigure 53 - Pilot (Propane/LP Gas)AutomaticIgnitorElectrodePilotBurnerManual IgnitorElectrodeB. Using Hand-Held Wireless RemoteControl1. Set manual ignition bypass switch on con-trol panel to OFF position (automatic igni-tion position).2. Wait five (5) minutes to clear out any gas.Smell for gas around heater and near floor.If you smell gas, STOP! Follow “B” in thesafety information on warnings plate. If youdon’t smell gas, go to the next step.3. Point remote control toward the lower frontof fireplace and push both buttons at thesame time. Hold for 6 seconds. The gasvalve will open and electronic ignition willbegin sparking to light the pilot.Note: Youwill be able to hear a clicking sound duringthis process. LED on wall switch will light.Note: You may be running this heater forthe first time after connecting to gas supplyor at the start of your heating season. If so,the ON button may need to be pressed again.This will allow air to bleed from gas system.If several attempts to light pilot fail, contacta qualified service person or gas supplier forrepairs. Until repairs are made, light and op-erate manually (see Manual Lighting In-structions for Electrical Power Outage).4. When pilot flame is lit, the thermocoupleis heated by the flame. When thermocouplebecomes hot (5 to 15 seconds), main burnerwill automatically light on high flame.5. To lower flame, point remote control to-ward lower front of fireplace and push HI/LO button once.Note: This fireplace does not have a pilot-only mode.TO TURN OFF GASTO APPLIANCEShutting Off Heater - Wall SwitchPush ON/OFF button on wall switch once.Shutting Off Heater - Wireless RemoteControlPoint remote control toward lower front of fire-place and push both buttons at the same time.MANUAL LIGHTINGINSTRUCTIONS FORELECTRICAL POWER OUTAGEWARNING: You must oper-ate this heater with the fireplacescreen in place. Make sure fire-place screen is in place beforerunning heater.NOTICE: During initial operation ofnew heater, burning logs will giveoff a paper-burning smell. Opendamper or window to vent smell.This will only last a few hours.Because this fireplace has an electronic ignitionsystem, in the event there is a loss of power, itwill be necessary to manually light the pilot withthe piezo ignitor. After the pilot is lit, the mainburner will light automatically.1. Follow steps 1 through 3 under NormalLighting Instructions, pages 26.2. Set manual ignition bypass switch on con-trol panel to ON position (manual ignitionposition). See Figure 54.3. The pilot is attached to the rear of the frontburner. You will be able to see the pilot andspark electrode without removing thescreen or logs.ONOFFHILOMANUALIGNITIONFigure 54 - Control LocationsManual IgnitionBypass Switch(Down is ON)MagneticManualOverrideHandle ON/OFFButtonHI/LOButtonPiezo IgnitorWall SwitchGas ValveLED LED