UPS SYSTEM INSTALLATIONEaton 9395 UPS (450–825 kVA) Installation and Operation Manual 164201725 Rev 4 www.eaton.com/powerquality 4-474.9.3 X-Slot ConnectionsNOTE LAN and telephone drops for use with X-Slot cards must be provided by the customer.NOTE When installing external wiring to X-Slot cards, conduit must be installed to the UPS cabinet. Wheninstalling internal wiring to X-Slot terminals, route the wiring through the internal opening in the X-Slotcommunication bay.For installation and setup of an X-Slot card, contact an Eaton service representative(see page 1-11).To install wiring to connections:1. If not already installed, install the LAN and telephone drops.2. Unfasten the front door latch and swing the door open (see Figure 4‐1 onpage 4-2).3. Remove the right interface entry conduit landing plate to drill or punch holes (seeFigure 4‐23 on page 4-27).4. Reinstall the interface entry plate and install the conduit.5. Route and install the LAN, telephone, and other cables to the appropriate X-Slotcards. See Figure 4‐34 on page 4-41 and Figure 4‐40 for X-Slot communicationbay locations.6. Close the door and secure the latch.7. Refer to the manual supplied with the X-Slot card for operator instructions.X-Slot Communication Bay 1 X-Slot Communication Bay 2X-Slot Communication Bay 3 X-Slot Communication Bay 4Figure 4‐40. X-Slot Communication Bays
