Eaton Cooper Power Series Installation Instructions Manual

Also see for COOPER POWER SERIES: Installation and operation instructions Installation instructions Installation instructions Installation and operation instructions Operation instructions

Contents

Eaton Cooper Power Series Installation Instructions Manual Manual pdf 11 page image

CL-7 control in Siemens Corporation controlboxTable 3 Kit parts identificationItem Description Part Number Qty1 CL-7 PRA wiring harness,Siemens/Howard controlA64316200F 12 Faceplate, Right E0003X00G29 13 Left Hinge Bracket E0003X00G32 14 Siemens Retro Kit MagnetAssembly57A643282002 15 Hinge 0800071097Z 26 Machine Screw: 6-32x0.38 0800071090Z 67 Lock Washer: #6 SS 0800070916Z 48 Lock Nut: 6-32 0800071115Z 29 Ground Lead E0003X00G160 110 Adhesive cable-tie anchors 0800069825Z 211 Cable tie 0800011079Z 2Required tools●● Screwdriver (standard)●● Screwdriver (Phillips head)●● 5/16-Inch nut driver or combination wrench●● 3/8-Inch nut driver or combination wrenchotee:N Verify all kit items are present before beginninginstallation procedure.Installation procedureFollow these instructions to install the CL-7 PRA on avoltage regulator manufactured by Siemens Corporation.1. Remove existing control per manufacturer‘srequirements. Retain the terminal block wing-nuts.otee:N If the Siemens Corporation style wiring harness(Figure 16), hinge and magnet assemblies(Figure 18) have already been installed on thecontrol, proceed to Step 14.otee:N The Siemens harness may be equipped withtwo wires colored white and white/blue withtwo-terminal connectors as shown in Figure 16. Thewires are for connection to the CL-7 control generalpurpose inputs (GPIs). The wires can be used foranalog voltage reduction or other programmablefunctionality. See document MN225003EN, CL-7Voltage Regulator Control Installation, Operation, andMaintenance Instructions for more information onthe GPIs.Figure 16 Siemens Corporation wiring harness for theCL-7 control (Item 1)2. Using a screwdriver, remove the four screws touninstall the existing latch bracket from the left side ofthe CL-7 control; retain the screws. See Figure 17.Figure 17 Removal of latch bracket from CL-7 control3. Install the left hinge bracket (Item 3) using the screwsretained from the last step. See Figure 18.4. Install the hinges (Item 5) using the provided screwsand washers (Items 6 and 7). See Figure 18.7CL-7 Control Panel RetrofitInstallatIon InstructIons MN225018EN April 2018