Eaton Cooper Power Series Installation Instructions Manual

Also see for COOPER POWER SERIES: Installation and operation instructions Installation instructions Installation instructions Installation and operation instructions Operation instructions

Contents

Eaton Cooper Power Series Installation Instructions Manual Manual pdf 20 page image

CL-7 control in Howard Industries control boxTable 7 Kit Parts IdentificationItem Description Part Number Qty1 CL-7 PRA wiring harness,Siemens/Howard controlA64316200F 12 Right Faceplate E0003X00G29 13 Latch E0003X00G31 14 Shoulder screw 0800071110Z 25 SS flat washer, #6 0800019079Z 26 Lock Nut, 6-32 hex 0800071115Z 17 Left hinge bracket E0003X00G32 18 Hinge E0003X00G47 29 SS machine screw, 6-32X0.38 0800071090Z 410 SS Lock washer, #6 0800070916Z 411 Ground lead E0003X00G160 112 Adhesive cable-tie anchors 0800069825Z 213 Cable tie 0800011079Z 2Required tools●● Screwdriver (standard)●● Screwdriver (Phillips head)●● 3/8-Inch nut driver or combination wrench●● 5/16-Inch nut driver or combination wrenchotee:N Verify all kit items are present before beginninginstallation procedure.Installation procedureFollow these instructions to install the CL-7 PRA on avoltage regulator manufactured by Howard Industries.1. Remove existing control per manufacturer‘srequirements. Retain the hinge pins and terminal blockwing-nuts.otee:N If the Howard Industries style wiring harness(Figure 41), hinge bracket and latch bracket(Figure 43) have already been installed on thecontrol, proceed to Step 14.otee:N The Howard Industries harness may be equippedwith two wires colored white and white/blue withtwo-terminal connectors as shown in Figure 41. Thewires are for connection to the CL-7 control generalpurpose inputs (GPIs). The wires can be used foranalog voltage reduction or other programmablefunctionality. See document MN225003EN, CL-7Voltage Regulator Control Installation, Operation, andMaintenance Instructions for more information onthe GPIs.Figure 41 Item 1, Howard Industries wiring harness forthe CL-7 control2. Using a screwdriver, remove the four screws touninstall the existing latch bracket from the left side ofthe CL-7 control; retain the screws. See Figure 42.Figure 42 Removal of latch bracket from CL-7 control3. Install the left hinge bracket (Item 7) using the screwsretained from the last step. See Figure 43.4. Install the hinges (Item 8) using the provided screwsand washers, (Items 9 and 10). See Figure 43.16CL-7 Control Panel RetrofitInstallatIon InstructIons MN225018EN April 2018