Product informationIntroductionThis document provides the instructions for retrofitting anEaton‘s Cooper Power™ series CL-7 control panel on anEaton, Siemens Corporation, General Electric, or HowardIndustries, Inc. 32-step voltage regulator.Read this manual firstRead and understand the contents of this manual andfollow all locally approved procedures and safety practicesbefore installing or operating this equipment. Read andunderstand the manuals detailing the installation andoperation of the regulator and the regulator control usedwith the regulator. Refer to document MN225003EN,CL-7 Voltage Regulator Control Installation, Operation,and Maintenance Instructions for information on the CL-7voltage regulator control. Refer to document MN225008EN,VR-32 Voltage Regulator with Quik-Drive™ Tap-ChangerInstallation, Operation, and Maintenance Instructions forinformation on Eaton‘s voltage regulator with Quik-Drivetap-changer.Additional informationThese instructions cannot cover all details or variationsin the equipment, procedures, or process described norprovide directions for meeting every possible contingencyduring installation, operation, or maintenance. For additionalinformation, please contact your Eaton representative.Acceptance and initial inspectionThis kit is thoroughly inspected at the factory. It is in goodcondition when accepted by the carrier for shipment.Upon receipt of the regulator kit, a thorough inspectionshould be made for damage, evidence of rough handling,or shortages. Should this initial inspection reveal evidenceof rough handling, damage, or shortages, it should benoted on the bill of lading and a claim should immediatelybe made with the carrier. Also, notify your Eatonrepresentative.Handling and storageBe careful during handing and storage of equipment tominimize the possibility of damage. If the regulator kit is notto be placed into immediate use, store the kit where thepossibility of damage is minimized.Quality standardsISO 9001 Certified Quality Management System1CL-7 Control Panel RetrofitInstallatIon InstructIons MN225018EN April 2018