Eaton D77A Installation And User Manual

Contents

Intelligent Technologies (IT.) D77A I/O Module Products48 For more information visit: www.EatonElectrical.com MN05002001EAppendix AData ParametersTable 33: 0x0001 (1) Production DataTable 34: 0x0002 (2) Consumption DataTable 35: 0x0003 (3) QCPort StatusTable 36: 0x0004 (4) Application Status (Available in I/O As Control Elements)Table 37: 0x0005 (5) Discrete Data Input (Available in I/O As Control Elements)Table 38: 0x0006 (6) Discrete Data Output (Available in I/O As Control Elements)Table 39: 0x006B (107) Analog Input Status (Available in I/O As Control Elements)* Setting the bit from “0” to “1” indicates that the condition is true.Size DescriptionVaries This list contains the concatenated values of QCPort Parameters specified in QCPort Configuration Parameter0x800C, Production List.Size DescriptionVaries This list contains the concatenated values of QCPort Parameters specified in QCPort Configuration Parameter0x800D, Consumption List.Size Description1 Byte This parameter indicates the QCPort fault condition that caused a device to enter the Fault Mode, as indicatedbelow:0x00 — No QCPort Fault0x01 — Node ID Conflict0x02 — Invalid Node ID in Master/Slave0x03 — Physical Node ID does not match actual ID0x04 — Duplicate configured nodes online0x05 — Dynamic Node ID overflow0x06 — Invalid baud rate selected0x07 — Errant Device fault0x08 — Problem with data in non-volatile memorySize Description2 Bytes This parameter indicates the application status of the QCPort device. It reports the most recent fault or warning.If there have been no faults or warnings, it reports 0. Reset clears this parameter.Size Descriptionn Bytes A series of BYTES that represent discrete digital inputs on a device. This parameter is used in any input modulehaving discrete inputs.The least significant bit of byte 0 corresponds to input point 0.Size Descriptionn Bytes A series of BYTES representing the state of the outputs of a discrete output device. This parameter is used inany module having discrete outputs. The least significant bit of byte 0 corresponds to output point 0.Parameter 0x8023, “Output Comm Loss Behavior” is used in conjunction with this parameter.Size Descriptionn Bytes This provides channel status for the analog inputs.U = Under RangeO = Over RangeByte Bit 7 Bit 6 Bit 5 * Bit 4 * Bit 3 Bit 2 Bit 1 * Bit 0 *0 O1 U1 O0 U01 O3 U3 O2 U2