6-2 IB02601006E www.eaton.comChapter 6:Using the IQ 250/260 IQ 250/260 MeterUsing the Front PanelYou can access four modes using the IQ 250/260 front panel buttons:• Operating Mode (Default)• Reset Mode• Configuration Mode• Information Mode. Information Mode displays a sequence of screens that show model information, such asFrequency and Amps.Use the Menu, Enter, Down and Right buttons to navigate through each mode and its related screens.NOTES:•Appendix A contains the complete Navigation Map for the front panel display modes and their screens.• The meter can also be configured using software; see Chapter 8 for instructions.Understanding Startup and Default DisplaysUpon Power Up, the meter displays a sequence of screens:• Lamp Test Screen where all LEDs are lit• Lamp Test Screen where all digits are lit• Firmware Screen showing build number• Error Screen (if an error exists).After startup, if auto-scrolling is enabled, the IQ 250/260 scrolls the parameter readings on the right side of thefront panel. The Kilo or Mega LED lights, showing the scale for the Wh, VARh and VAh readings. Figure 6.3shows an example of a Wh reading.The IQ 250/260 continues to provide scrolling readings until one of the buttons on the front panel is pressed,causing the meter to enter one of the other Modes.Figure 6.3: Wh Reading
