Eaton Network Card-MS User Manual

Also see for Network Card-MS: Quick start instructions Quick start

Contents

Class B EMC StatementsFCC Part 15 Class BThis equipment has been tested and found to comply with the limits for a Class B digital device, pursuant topart 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmfulinterference in a residential installation. This equipment generates, uses and can radiate radio frequency energyand, if not installed and used in accordance with the instructions, may cause harmful interference to radiocommunications. However, there is no guarantee that interference will not occur in a particular installation. Ifthis equipment does cause harmful interference to radio or television reception, which can be determined byturning the equipment off and on, the user is encouraged to try to correct the interference by one or more ofthe following measures:l Reorient or relocate the receiving antenna.l Increase the separation between the equipment and the receiver.l Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.l Consult the dealer or an experienced radio/TV technician for help.Requesting a Declaration of ConformityUnits that are labeled with a CE mark comply with the following harmonized standards and EU directives:l Safety for ATI: IEC/EN 60950-1 2002l EN 61000-6-2 (2002)EN 61000-6-3 (2002)IEC/EN 62040-2 (2002).l EU Directives: 99/336/EEC and 93/68/EEC.Low voltage: 73/23/EEC and 93/68/EEC.The EC Declaration of Conformity is available upon request for products with a CE mark. For copies of the ECDeclaration of Conformity, contact:Eaton Power Quality OyKoskelontie 13FIN-02920 EspooFinlandPhone: +358-9-452 661Fax: +358-9-452 665 68Eaton is a registered trademark of Eaton Corporation or its subsidiaries and affiliates. Phillips and Pozidriv are aregistered trademarks of Phillips Screw Company. National Electrical Code and NEC are registered trademarksof National Fire Protection Association, Inc. All other trademarks are properties of their respective companies.©Copyright 2011 Eaton Corporation, Raleigh NC, USA. All rights reserved. No part of this document may bereproduced in any way without the express written approval of Eaton Corporation.