Eaton Network Card-MS User Manual

Also see for Network Card-MS: Quick start instructions Quick start

Contents

Eaton Network Card-MS User’s Guide P-164000100—Rev 1 www.eaton.com/powerquality 1Chapter 1 IntroductionThe Eaton ® Network Card-MS works with Eaton UPS Management Software to monitor, manage, and protectuninterruptible power supplies (UPSs) through standard Web pages, a Network Time Protocol (NTP) server,and Secure Sockets Layer (SSL) security protocol. The Network Card-MS can support up to five connectedbrowsers at a time, or three with SSL protocol.You can configure the card while the UPS is online with any one of the following options:l Web browserl Telnet, Secure Shell (SSH), and command line interface (CLI)l Local serial link using network parametersl Bootstrap Protocol/Dynamic Host Configuration Protocol (BOOTP/DHCP) using network parametersl Uses the following well-known and registered port numbers for protocol connections:- BootP, DHCP UDP: 68, 67- HTML TCP: 80- SSL TCP: 443- NSM in connected mode TCP: 5000- NSM in UDP broadcast mode: 4679 and 4680- SMTP: 25- NTP: 123- SNMP V1&V3: 161- TRAP SNMP: 162- TELNET: 23- SSH: 22l In addition, the Network Card-MS has the following features:l Simultaneous access of up to five connected browsers (three in SSL)l Configuration of automatic e-mail message in response to UPS alarms and to transmit periodic reportsl Control of UPS on/off switching with a Web browserl Adjustment and control of load segments through the Web interface, including sequential starting of theinstallation and optimization of backup time by shutting down non-priority systemsl Automatic shutdown of UPS-protected computers with NetWatch client softwarel Measurement of humidity and temperature with the optional Environmental Monitoring Probe (EMP)l Automatic data and time adjustment through an NTP serverl Protection by encrypted passwordl Protection by secure SSL connectionl Log storage in the non-volatile memoryl Available languages:- English- French- German- Italian- Spanish- Portuguese