Eaton Network Card-MS User Manual

Also see for Network Card-MS: Quick start instructions Quick start

Contents

Using the Telnet/SSH/CLI InterfaceEaton Network Card-MS User’s Guide P-164000100—Rev 1 www.eaton.com/powerquality 62Default Login/PasswordIf the login or password is lost, select the “Set login password to default” menu option to enable the defaultLogin/Password.Default ConfigurationUse the “Default configuration” menu option to enable the default configuration. The Network Card-MSautomatically restarts after the default configuration is enabled.Example #> getHum OffsetsetHum To modify a humidity settingSyntax setHum [option1] [option2] ...Options HighThreshold = xxLowThreshold =xxHysteresis = xx (0..5)Offset = xx (-5..5)HighNotify = 0|1 (0=No, 1=Yes)LowNotify = 0|1 (0=No, 1=Yes)HighShutdown = 0|1 (0=No, 1=Yes) (NOTE 1)LowShutdown = 0|1 (0=No, 1=Yes) (NOTE 1)Example #> setHum HighNotify=0Comments (NOTE 1) : Writing enabled only if the notification is enabledgetInput1 or getInput2 To read input settingSyntax getInput1 [option1] [option2] ...Options iNameState[0].DescriptionState[0].NotifyState[0].ShutdownState[1].DescriptionState[1].NotifyState[1].ShutdownExample #> getInput1 iNamegetInput1 or serInput2 To modify input settingSyntax setInput1 [option1] [option2] ...Options iName = “xx..xx”State[0].Description = “xx..xx”State[0].Notify = 0|1 (0=No, 1=Yes)State[0].Shutdown = 0|1 (0=No, 1=Yes)State[1].Description = “xx..xx”State[1].Notify = 0|1 (0=No, 1=Yes) (NOTE 1)State[1].Shutdown = 0|1 (0=No, 1=Yes) (NOTE 1)Example #> setInput1 State[0].Label = “Door open” State[0].Notify = 1Comments (NOTE 1) : Writing enabled only if the notification is enabledTable 21. Environment Commands (Continued)