Eaton P1RX 240Vac Max Instruction Manual

2Pow-R-Line X Retrot Panelboards Pow-R-Line X RetRofit PaneLboaRds MN014011EN January 2020 eatoncanada.caPre-Installation: Receiving, Handling andStorageReceivingUpon delivery, use the packing list to confirm the numberof items against what was received to ensure that theshipment is complete. Any discrepancies should be notedon the freight bill before signing. Report any shortages ordamage to the freight carrier immediately.Immediately upon receipt of the panelboard interior andtrim, the packaging should be carefully removed and athorough inspection of each section should be made todetect any damage incurred during shipment. Any damageshould be noted on the bill of lading (freight bill) and theconsignee receiving the equipment should notify the freightcarrier.FAILURE TO NOTIFY THE FREIGHT CARRIER OF DAMAGEIN A TIMELY MANNER MAY RESULT IN THE CONSIGNEEASSUMING THE COSTS ASSOCIATED WITH REPAIR ORREPLACEMENT OF DAMAGED EQUIPMENT.After inspection, the components should be returned to itspackaging until it is ready for installation.HandlingDepending on the configuration, panelboards may weighin excess of 100 pounds. Before moving or lifting, verifythat the panel is within safe limits of the installers liftingcapacity.StoragePanelboards, which cannot be immediately installed andenergized, should be stored in an indoor dry, clean andheated environment.Do not store in areas where conditions such as dampness,changes in temperature, cement dust or a corrosiveatmosphere is present.WARNINGHAZARDOUS VOLTAGE. WILL CAUSE SEVERRE INJURY ORDEATHWARNINGONLY THOSE PROFESSIONALS TRAINED AND QUALIFIEDON ELECTRICAL DISTRIBUTION PANELBOARDS SHOULDINSTALL AND/OR SERVICE THIS EQUIPMENTRemoval of Existing Panelboard InteriorDO NOT work on electrical equipment while energized.Verify power entering the equipment is de-energized atthe source.Follow appropriate lockout procedure to this panel beforestarting work.Electrical Disconnection of Existing PanelboardAfter panel has been de-energized and the feeder device islocked out, removal procedure can begin.Carefully identify all connections, load and line payingparticular attention to main incoming phasing.Identify correct phasing on the mains and disconnect allphases, neutral and ground connections.Identify and disconnect all load wires (line & neutral)connected to existing branch breakers, noting currentvalues. Before proceeding, it is important to verify that theline and load cables (phase, neutrals and grounds) are longenough to connect to the new interior.Proceed to disconnect all electrical connections attached tothe existing interior. Once the conductors are disconnectedfrom the old interior, the cables should be formed in thespace provided. Care should be taken in forming insulatedcables to ensure that no insulation is forced permanentlyagainst the edges of any metal parts.Removal of Existing InteriorRemove all chassis mounting hardware. Carefully removechassis to ensure that cable insulation is not damaged bysharp edges.To allow for adequate bonding, all attempts should be madeto utilize existing mounting studs/system in the enclosureIf it is not feasible to use existing mounting system, removeall protrusions to allow for a flat mounting surface.Installation of RetroFit Panelboard InteriorRemoval of Dead-front coverRemove the interior from packaging.Place on a solid worksurface, remove qty 4 ¼-20 screws that fasten the dead-front cover to the chassis – (see Fig. A). Place dead-frontcover and hardware in a safe location to prevent damage.