Eaton P1RX 240Vac Max Instruction Manual

3Pow-R-Line X Retrot PanelboardsPow-R-Line X RetRofit PaneLboaRds MN014011EN January 2020 eatoncanada.caFigure A: Mount Dead-front Cover to ChassisLocating Interior Mounting Holes in EnclosureIn most instances the chassis should be centered in theenclosure unless a special offset trim has been ordered.Measure and draw vertical and horizontal centerlines.Usingthese marks, support the interior in the enclosure and markthe 4 holes that are located on the center axis.See figure below.Re-verify that all electrical conductors long enough to beterminated properly.Ensure main incoming cables are longenough to reach Main and Neutral termination locationswithout compromising wire bending space requirements aslisted in the Appendix Table 3.Ensure that electrical clearance requirements aremaintained per NECTM/CECTM.Care must be taken to ensurethat the trim will completely cover openings inthe enclosure.If not using existing mounting hardware, mark minimum of8 mounting locations, on the back of the enclosure. Drill andtap 10-32 holes as per Fig. BFigure B: Recommended Mounting LocationsDetermine proper depth settingTo determine preset depth of the chassis, place anon-conducting, insulated straight edge across the finished wallsurface and measure to the rear of the enclosure. See Fig.CFigure C: Measuring Depth of EnclosureLoosen qty. 8, 10-32 screws Fig. D installed atthe chassis corners.Figure D: Depth Adjustment Bracket ScrewsSet chassis depth by aligning bottom edge of interiormounting rail with the appropriate depth as determined bythe measurement obtained inn the previous step. Torque#10-32 screws to 24 in-lbs.Install InteriorInstall interior using mounting holes drilled and tapped inprevious steps using supplied 10-32 hardware.Figure E: Verifying Depth of Mounting