Communication13-3EATON Powerware® 9390 UPS (100–160 kVA) Installation and Operation Manual S 164201554 Rev E powerware.comRemote Notification is an extension of the Terminal mode with the additional supportalgorithms necessary to control an external modem. Connection to the UPS is made whena user calls the UPS on the phone. The user has exactly the same capabilities as if using aterminal connected directly to an RS-232 port.Remote Notification differs from the basic Terminal mode with the addition the followingfunctions: Call AnswerThe Call Answer function allows the user to call into the UPS from a remote locationand enter Terminal mode. Call OutThe Call Out function allows the UPS to be configured to call either a remote computeror numeric paging service over the phone line. Call Out allows the UPS to call a remotecomputer and leave a one-line descriptive message of the alarm or notice condition.Numeric paging support allows the UPS to call a paging service and send numericmessages. HousekeepingThe Housekeeping function maintains the link between the UPS and modem.13.4 Terminal ModeNOTE The brackets ([ ]) in the following bullets indicate standard keyboard characters.To use a key combination, hold down the Escape key and press the indicated letter key.In Terminal mode, the user can request the following: [ESC] [V] displays the UPS control panel. [ESC] [H] displays the Event History. [ESC] [N] displays the Node Bits Setup. [ESC] [L] displays any new event. [ESC] [B] displays the Battery Log.13.4.1 Display UPS Control PanelWhen this function is invoked, a facsimile of the UPS control panel is displayed on theterminal screen. All controls are functional and can control the UPS remotely. The onlyexception is the Load Off control which requires the operator to press and hold the localcontrol for two seconds to shut down the UPS.To remotely control the UPS or view UPS information, use the escape key legend tocontrol the function normally controlled by the control panel softkeys. See Chapter 9,“Using the Control Panel,” for instructions on navigating the control panel.
