32INM 725B Rev 212 17 WRP Cell Detail (Watchdog Relay Card - Remote Pushbutton)Cell type WRP is used to provide:-Four channel relay card which provide• Four Common Relays which can be programmed for use as horn, common alarm orwatchdog relays.• Each of the output contacts can be set to N/C or N/O using a 3 way header and 2 wayshorting bar located on the card.• The non alarm coil state of each relays can be programmed to be either EN or DE-ENRemote Pushbutton Card that provides:• Six external pushbutton inputs for use with optional remote mounting pushbuttonsas required.• Each of the external pushbutton inputs can be programmed to operate as either:- LampTest, Silence, Acknowledge, Reset, 1st Reset or System Test or Sleep Mode asrequired. The common return for all remote pushbuttons is +V (+24VDC)WARNING !Remote pushbuttons must be installed in the same enclosure as theRTK 725B/C annunciator.WRPCOMMON RELAYSREAR VIEWPUSHBUTTONSP2P1 P4P3 P6P5REMOTE PB CARD VERSIONS USED IN "WRP" CELLS(UPPER SLOT)CB9427POP1 – REMOTE PUSHBUTTON CARDCR4CR3CR2CR1CB6641POP1 - WATCHDOG / RELAY CARDRELAY CARD VERSION USED IN "WRP" CELLS(LOWER SLOT)
