Eaton S801+ Series User Manual

Contents

InstallationS801+ Soft Starter MN03900002E—November 2012 www.eaton.com 13Lug Installation, S801+N… and S801+R…Wire the appropriate line and load conductors to the Softstarter in accordance with federal and local codes. Torquefasteners per table on Page 11.Lug Installation, S801+T…, S801+U…, andS801+V… Frames1. Remove line and load terminal lug covers by removingthe screws that hold each cover onto the soft starter.2. With screws removed, slide the covers off the unit.3. Position lugs and install lug mounting hardwareaccording to the instructions included in the kit. Tightenlug mounting hardware included in the kit to 120 Lb-in(13.6 Nm).4. Install line and load conductors and torque hardware inaccordance with table on Page 11.5. Slide the line and load lug covers back into their originalpositions.6. Secure with the screws previously removed.S801+V… Shown with Terminal Cover Removed andEML30 Lug Kit Installed on Load SideControl Wiring InputsControl wiring is connected to the S801+ by one (1) terminalblock and one (1) RJ12 connection located at the front ofthe unit.Control Terminal Block—A 12 position connector is utilized tomake connections for 24 Vdc control power, soft startercontrol function commands, and Auxiliary Relay functions.A 3 position screw connector utilized to make connectionsfor factory use only and is not utilized with S801+ operations.User Interface Module Terminal Block—An RJ12 connectionutilized to make the connection to the Control InterfaceModule (CIM).Control Terminal BlockDIP SwitchSwitch S1 selects Edge (ON) or Level (OFF) sense detectionon the Run1 input on control block Terminal 1 (default).Switch S2 is not functional on the S801+.Switches 32–1 are not functional on the S801+.DIP SwitchAdditional information on Level and Edge Sensing may befound in Functional Description starting on Page 23.12481632S2S1On