66InStALLAtIonAnd opErAtIon mAnuAL25-13741-COctober 2018www.eaton.com12. Communication12.5 Receiving a call at the panel handsetPanel handset configured to view the ringing outstation will ring and the name ofthe calling outstation will appear on the LCD display. The operator can then lift thehandset and connect to the calling extension.If more than one line is calling, all calling lines show in the display, and can be scrolledthrough with the navigation buttons and selected.12.6 Making a call from the panel handsetLift the handset on the control phone. Dial the number of the outstation / panel andpress ‘ACCEptCall’ to call, the line will connect automatically when the remotehandset is lifted (Type A) or the call button is pressed (Type B).12.7 Ending a call at panel handsetActive call can be ended by placing the handset back in the housing. If other calls areon ‘HoLd’, active call is ended by pressing the ‘End Call’ key on panel. Next call canthen be selected from using ‘ACCEptCall’ key.DD/MM/YYHH:MM0101:PANEL XXOUTSTATION 10102:PANEL XXOUTSTATION 2ENGINEER7 Manage Users8 Display Settings9 SystemTime / DateSystem Service Date1011 Install12 Test(11-12)INSTALL1 System Settings2 Names3 Receive Calls4 Outstation Learn5 Update Software(4-5)ENGINEER1 Accept Faults(4-12)DD/MM/YYDD/MM/YYHH:MM0101:PANEL XXOUTSTATION 10102:PANEL XXOUTSTATION 2DD/MM/YYHH:MM0101:PANEL XXOUTSTATION 10102:PANEL XXOUTSTATION 2DD/MM/YYHH:MM0101:PANEL XXOUTSTATION 1System OKDD/MM/YYHH:MMDD/MM/YYHH:MM0101:PANEL XXOUTSTATION 10102:PANEL XXOUTSTATION 2ENGINEER1 Accept Faults2 Fault Log3 Event Log4 Call Log5 Panel Information6 Manage Logs(1-12)Accept Faults (1-3)02/03/18 10:54.30Mic. Open Circuit206/03/18 09:05.50Speaker Open Circuit3System OKDD/MM/YYENGINEER1 Accept Faults2 Fault Log3 Event Log4 Call Log5 Panel Information6 Manage Logs(1-12)Accept Faults (1-3)02/03/18 10:54.30Mic. Open Circuit206/03/18 09:05.50Speaker Open Circuit3System OKDD/MM/YYPANEL XXOUTSTATION 10101HH:MMDD/MM/YYHH:MM0101:PANEL XXOUTSTATION 10102:PANEL XXOUTSTATION 2