Eaton xComfort User Manual
Also see for xComfort: Technical information
                        | |
Contents
|
xComfort Room Controller Touch User Manual 1v00_EN 1 | P a g e1. Introduction1.1 Safety instructionsThis document contains important warnings and safety instructions which must be observed andfollowed by the users. Failure to follow these warnings and safety instructions will put the fault-freeoperation of the Room Controller Touch at risk.1.2 Intended useThe Room Controller Touch has been designed solely for residential use in private homes and smalloffices. It is not suitable for industrial use.The Room Controller Touch is designed to facilitate the climate control in a room and provide the useraccess to this through an intuitive LCD Touch screen menu.The Room controller can operate in two application modes:• Control mode; in which the Room Controller Touch controls the regulation of the climate in a room• Sensor mode; in which the Room Controller Touch registers the room climate conditions and theuser settings and sends them to an intelligent device, e.g. xComfort Smart Home Controller (SHC),which actually controls the climate in the room.Since the transmission of radio signals is based on a non-exclusive communication channel,interference to the transmission are possible. Because of this, the Room Controller Touchmust not be used to control components with safety-related functions, such asoverheating protection, emergency stop or emergency call.The use of the unit for any purpose other than described in this document or the failure to observe thewarnings and safety instructions it contains will immediately invalidate any claims in respect to thewarranty and/or liability.1.3 Instructions for disposalDo not dispose of this device with regular domestic waste.Electronic equipment must be disposed of at local collection points for waste electronicequipment and in compliance with the local regulations governing waste electrical and electronicequipment.1.4 About this documentThese operating instructions are intended for end users and describe the operation and menu structureof the Room Controller Touch.Certain functions and their availability depend on the configuration of the Room Controller Touch duringthe installation. These functions are marked with (Optional).Please contact a suitable qualified electrical engineer for all assembly, installation andbasic configuration requirements or if you need to remove or dispose of the device.Faulty installation or configuration can otherwise cause damage to property and persons. |
Related manuals for Eaton xComfort
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine