INSTALLATIONCheck the appliance is electrically safe and gas sound when you have finished.27ArtNo.011-0007 - Restraining chain (AUS)RestrainingchainFitting the Stability Bracket and Chainnn A stability bracket and chain MUST be fitted whenthe cooker is connected to a flexible gas supply.Unless properly installed, the cooker could be tipped byleaning on the door. Injury might result from spilled hotliquids or from the cooker itself.IMPORTANT: The cooker must be set to the correct heightand levelled before the stability bracket is installed.Fitting a Stability BracketWhen fitting a stability bracket please refer to the instructionssupplied with the bracket for further details on fitting.When fitting a stability bracket (Fig.7-6 and Fig.7-7) adjustthe bracket to give the smallest practicable clearancebetween the bracket and the engagement slot in the rear ofthe cooker.Fit the bracket so that it engages as far as possible over thechassis of the cooker.Fitting the Restraining ChainThe restraining chain MUST be fitted.The length of chain between the appliance and the wall fixingshould prevent strain on the gas and electricity connections,but still allow access to unhook the chain when the cooker ispull forward.Measure the length of chain required. Use the clamp suppliedto clamp onto the gas pipe (Fig.7-8). Fix the supplied hooksecurely to the wall.LevellingYou are recommended to use a spirit level on a shelf in one ofthe ovens to check for level.Place the cooker in its intended position taking care not totwist it within the gap between the kitchen units as damagemay occur to the cooker or the units.The front feet and rear rollers can be adjusted to level thecooker.To adjust the height of the rear of the cooker use a 13 mmspanner or socket wrench to turn the adjusting nuts at thefront bottom corners of the cooker.To set the front, turn the feet bases to raise or lower.ArtNo.070-0014 - Stability bracket - Wall fittingCookerStability bracketFloor3 mm minTypical floor mountingCookerOuter stabilitybracketFloorWall3 mm minTypical wall mountingFig.7-7Fig.7-8Fig.7-6