GE 39-40425 Installation Instructions Manual

Place the mounting plate against the wall andinsert the toggle wings into the holes in the wallto mount the plate.NOTE: Before tightening the toggle bolts and thewood screw(s), check again to be sure that themounting plate is level and centered left to right.CAUTION: Be careful to avoid pinching fingersbetween the back of the mounting plate and the wall.Tighten all bolts. Pull the plate away from thewall to help tighten the bolts. Be careful not toover-torque the toggle bolts.3A4ATTACH THE MOUNTINGPLATE TO THE WALLA1.12OUTSIDE TOP EXHAUST (Vertical Duct)Remove the template from the rear wall. Themounting plate must be secured to the wall using atleast 3 toggle bolts and one wood screw. The woodscrew must engage a wall stud.Remove the toggle wings from the bolts.Insert the bolts into the mounting platethrough the holes designated to go into drywalland reattach the toggle wings to 3⁄4″ onto each bolt.1INSTALLATION OVERVIEWA1. Attach Mounting Plate to WallA2. Prepare Top CabinetA3. Check Damper OperationA4. Mount Microwave OvenA5. Adjust Exhaust AdaptorA6. Connect DuctworkWallMountingPlateSpacing for TogglesMore Than WallThicknessBolt EndToggleBoltToggle WingsTo use toggle bolts:Installation Instructions2