GE 39-40425 Installation Instructions Manual

USE TOP CABINET TEMPLATEFOR PREPARATION OF TOPCABINETB3.• Read the instructions on the TOP CABINETTEMPLATE.• Tape it underneath the top cabinet.• Drill the holes, following the instructions on theTOP CABINET TEMPLATE.CAUTION: Wear safety goggles when drilling holesin the cabinet bottom.WallMountingPlateSpacing for Toggles MoreThan Wall ThicknessToggleBoltToggle WingsTo use toggle bolts:Bolt EndInstallation InstructionsThe top cabinet template will help you locate the topsupport screw holes and power cord cutout.Place the mounting plate against the wall andinsert the toggle wings into the holes in the wallto mount the plate.NOTE: Before tightening the toggle bolts and thewood screw(s), check again to be sure that themounting plate is level and centered left to right.CAUTION: Be careful to avoid pinching fingersbetween the back of the mounting plate and the wall.Tighten all bolts. Pull the plate away from thewall to help tighten the bolts. Be careful not toover-torque the toggle bolts.3421 Remove the back top center blower motor doorretaining screw.ADAPTING MICROWAVEBLOWER FOR OUTSIDEBACK EXHAUSTB4.Open the blower door by lifting it up at the backside of the microwave. Remove and save the topand back retaining screws that hold the blowermotor in the microwave.Back ofMicrowaveBlower MotorBlower DoorScrew16RetainingscrewRetainingscrewATTACH THE MOUNTINGPLATE TO THE WALLB2.Remove the template from the rear wall. Themounting plate must be secured to the wall using atleast 3 toggle bolts and one wood screw. The woodscrew must engage a wall stud.Remove the toggle wings from the bolts.Insert the bolts into the mounting plate throughthe holes designated to go into drywall and reattachthe toggle wings to 3⁄4″ onto each bolt.12