GE 39-40425 Installation Instructions Manual

USE TOP CABINET TEMPLATEFOR PREPARATION OF TOPCABINETC2.RECIRCULATING (Non-Vented Ductless)INSTALLATION OVERVIEWC1. Attach Mounting Plate to WallC2. Prepare Top CabinetC3. Check Microwave AssemblyC4. Adapt Blower for RecirculationC5. Mount the Microwave OvenC6. Install Charcoal Filter• Read the instructions on the TOP CABINETTEMPLATE.• Tape it underneath the top cabinet.• Drill the holes, following the instructions on theTOP CABINET TEMPLATE.CAUTION: Wear safety goggles when drilling holesin the cabinet bottom.Installation InstructionsThe top cabinet template will help you locate the topsupport screw holes and power cord cutout locations.CPlace the mounting plate against the wall andinsert the toggle wings into the holes in the wallto mount the plate.NOTE: Before tightening the toggle bolts and thewood screw(s), check again to be sure that themounting plate is level and centered left to right.CAUTION: Be careful to avoid pinching fingersbetween the back of the mounting plate and the wall.Tighten all bolts. Pull the plate away from thewall to help tighten the bolts. Be careful not toover-torque toggle bolts.43ATTACH THE MOUNTINGPLATE TO THE WALLC1.Remove the template from the rear wall. Themounting plate must be secured to the wall usingat least 3 toggle bolts and one wood screw. Thewood screw must engage a wall stud.Remove the toggle wings from the bolts.Insert the bolts into the mounting plate throughthe holes designated to go into drywall andreattach the toggle wings to 3⁄4″ onto each bolt.1WallMountingPlateSpacing for TogglesMore Than WallThicknessBolt EndToggleBoltToggle WingsTo use toggle bolts:219