GE 39-40425 Installation Instructions Manual

ADAPTING MICROWAVEBLOWER FORRECIRCULATION (cont.)C3.21Cabinet FrontCabinet Bottom ShelfFiller BlockMicrowave Oven TopEquivalent to Depthof Cabinet RecessInstallation Instructions3MOUNT THE MICROWAVE OVENFOR EASIER INSTALLATION AND PERSONALSAFETY, WE RECOMMEND THAT TWO PEOPLEINSTALL THIS MICROWAVE OVEN.NOTE: If your cabinet is metal, use the nylongrommet around the power cord hole to preventcutting of the cord.NOTE: We recommend using filler blocks if thecabinet front hangs below the cabinet bottom shelf.IMPORTANT: If filler blocks are not used, casedamage may occur from overtightening screws.Insert a self-aligning screw through top centercabinet hole. Temporarily secure the oven byturning the screw at least two full turns after thethreads have engaged. (It will be completelytightened later.) Be sure to keep power cordtight. Be careful not to pinch the cord, especiallywhen mounting flush to bottom of cabinet.NOTE: When mountingthe microwave oven,thread power cordthrough hole in bottom oftop cabinet. Keep it tightthroughout Steps 1–3. Donot pinch cord or liftoven by pulling cord.Lift microwave, tiltit forward and hookslots at back bottomedge onto four lowertabs of mountingplate.Self-Aligning Screw2 Rotate front of ovenup against cabinetbottom.1Close the blower cover and secure it with thescrew removed in Step 1.7 Secure the blower unit to the microwave withthe two screws removed in Step 2.6 Tilt and place the blower unit back into theopening in the top of the microwave.8CAUTION: Do not pull or stretch the blowerunit wiring. Make sure the wires are notpinched.RetainingscrewRetainingscrewC4.