9DETERMINING WALL PLATE LOCATION UNDER YOUR CABINETC.Your cabinets may have decorative trim that interfereswith the microwave installation. Remove the decorativetrim to install the microwave properly and to make itlevel.On cabinets with a front overhang, draw a line on theback wall at the same depth as the overhang. Align thetemplate to match overhang depth. This will keep themicrowave level.Measure the inside depth of the front overhang.Draw a horizontal line on the back wall to matchthe depth of the front overhang. See illustration.Draw a vertical line on the wall at the center of the30″ to 36″ space. Trim the template on the dotted line.Tape the Rear Wall Template to the wall using themarked centerline and top line as a guide.Template beneath cabinetwith flat bottomTemplate aligned with front overhangon cabinet bottomDraw a line on theback wall equal to thedepth of the frontoverhang. Trim therear wall templatealong the dotted line.Template beneath cabinetwith recessed bottomInstallation Instructions16-1/2″123Draw a vertical line on the wall atthe center of the 30″ or 36″ space.Tape the Rear Wall Template ontothe wall matching the centerline andtouching the bottom cabinet frame.Draw a vertical line on the wall atthe center of the 30″ to 36″ widespace. Tape the Rear Wall Templateonto the wall matching thecenterline and touching the bottomof the cabinet.16-1/2″16-1/2″CLCLCLTrim the rear walltemplate alongthe dotted line.THE MICROWAVE MUST BE LEVEL.Use a level to make sure the cabinet bottom is level.Trim the rear walltemplate alongthe dotted line.