GE 39-40425 Installation Instructions Manual

Close the blower cover.7 Secure the blower unit to the microwave withthe two screws removed in Step 2.6Roll the assembled blower unit so that theblack-colored exhaust outlet faces the back ofthe microwave and the gray-colored inlet sleevefaces downward. NOTE: The gray-colored sleeveopening must ALWAYS face downward to ensureproper operation of the microwave.543ADAPTING MICROWAVEBLOWER FOR OUTSIDEBACK EXHAUST (cont.)B4.Carefully slide the blower motor toward the right,and lift it partially out of the opening. Note: Theblower wires are long enough to allow flexiblehandling while performing these steps. Disconnectthe wires only if it is necessary for additionalflexibility.Remove the two screws holding the gray-coloredinlet sleeve to the blower unit. Rotate the graysleeve as shown until the gray arrow lines up withthe “B”, back exhaust. Reinstall the two screws.Back ofMicrowaveTilt and place the blower unit back into theopening in the top of the microwave.Back ofMicrowave8Attach the exhaust adaptor to the rear of themicrowave by sliding it into the guides at thetop center of the back of the oven.9Installation InstructionsPush in securely until it is in the lower lockingtabs. Take care to assure that the damper hingeis installed so that it is at the top and that thedamper swings freely. Reinstall the originalblower motor screw through the adaptor andinto the back of the microwave.GuideGuideAdaptorLocking TabsBack ofMicrowaveRemove screws fromGray Inlet SleeveCAUTION: Do not pull or stretch the blowerunit wiring. Make sure the wires are notpinched.Retainingscrew17RetainingscrewBlower Motor ScrewBlackExhaustOutletMust FaceDownwardBack of Microwave