C-4 Series 90™-30 PLC LONWORKS® Bus Interface Module User's Manual – June 1997 GFK-1322ACTable C-5. - ContinuedModule Control %Qlocations8 bits of %Q register (mapped to first location).Bit 1: Reset Module (hardware reset)Bit 2: Send Service Pin MessageBits 3-8: reserved for future use.Parameter 0 definition Created from Network Variable Definition File (.XIF) file.Config File/Init FiledefinitionCreated from Network Variable Definition File (.XIF) file.Hand Held Programmer By setting the maximum parameter to 1, and parameter 1 to the text "Last Parameter", the API willhandle all commands from the Hand Held Programmer attached to the PLC CPUDependent parameters None (API skip table not used).Configuration Freeze Not UsedPacking of Discrete NVsinto %I, %QSNVT_lev_disc, SNVT_switch supported.Configuration Parameter TypesStandard Configuration Parameter Types (SCPTs) are used to transfer node configurationinformation via the LON T ALK File Transfer protocol. SCPTs provide a means of handling largeamounts of configuration information on a node. SCPTs do not use network variable resourcesand are downloaded and uploaded to a node via the LON T ALK file transfer protocol.