GE AF-600 FP Design And Installation Manual

Also see for AF-600 FP Series: Quick installation guide Quick guide Operating instructions Operating instructions Operating instructions

Contents

Operation StatusRamping The motor is accelerating/decelerating usingthe active ramp-up/down. The reference, alimit value or a standstill is not yet reached.Ref. high The sum of all active references is above thereference limit set in H-75 Warning ReferenceHigh.Ref. low The sum of all active references is below thereference limit set in H-74 Warning ReferenceLow.Run on ref. The adjustable frequency drive is running inthe reference range. The feedback valuematches the setpoint value.Run request A start command has been given, but themotor is stopped until a run permissive signalis received via digital input.Running The adjustable frequency drive runs themotor.Sleep Mode The energy saving function is enabled. Themotor has stopped, but will restart automat-ically when required.Speed high Motor speed is above the value set inH-73 Warning Speed High.Speed low Motor speed is below the value set inH-72 Warning Speed Low.Standby In Auto On Auto mode, the adjustablefrequency drive starts the motor with a startsignal from a digital input or serial communi-cation.Start delay In F-24 Holding Time, a delay starting time wasset. A start command is activated and themotor will start after the start delay timeexpires.Start fwd/rev Start forward and start reverse were selectedas functions for two different digital inputs.The motor starts in forward or reversedepending on which corresponding terminal isactivated.Stop The adjustable frequency drive has received astop command from the keypad, digital inputor serial communication.Trip An alarm occurred and the motor is stopped.Once the cause of the alarm is cleared, theadjustable frequency drive can be resetmanually by pressing [Reset] or remotely bycontrol terminals or serial communication.Operation StatusTrip lock An alarm occurred and the motor is stopped.Once the cause of the alarm is cleared, powermust be cycled to the adjustable frequencydrive. The adjustable frequency drive can thenbe reset manually by pressing [Reset] orremotely by control terminals or serialcommunication.Table 8.3Status Messages AF-600 FP Design and Installation GuideDET-768A 8-38 8