– 15 –Demo ModeThe sales demo mode will allow dealers to demonstrate all oven functionality with one exception. (See #1below.)The sales demo mode can only be entered during the initial Clock: Set hour display that occurs when the unitpowers up after a long (greater than 60 seconds) power outage.When sales demo mode is initiated, 2 short-beeps are sounded and all oven functions will operate with thefollowing exceptions;1. No power shall ever be applied to the heaters, halogen lamps, magnetron high voltage transformer, orInrush control relays. The control relays for any of these loads shall not be switched during sales mode.2. The DEMO icon will be lit whenever the unit is in sales mode regardless of settings or the feature beingselected.The sales demo mode is cleared by holding the START/PAUSE and HELP pads down at same time for a full3 seconds. The sales mode can only be cleared during the same initial Clock: Set hour display that occurswhen the unit powers up after a long (greater than 60 seconds) power outage. After 5 seconds elapse, allfunctions of the oven will return to normal operation.The sales demo mode will be initiated by holding the START/PAUSE and HELP pads down at the same timefor a full 3 seconds.Demo Mode OnDemo Mode OnClock: Set hourClock: Set hourAMAMPushPush DialDial to setto set0:000:00Demo Mode OffDemo Mode OffWhen power-up occurs, software will check the special sales demo identier code. If the code is set, then theoven will stay in the sales demo mode. This will prevent the unit from powering back up to a normal mode ifpower to the salesroom had gone off.