GE Advantium PSA2200R Technical Service Manual

Also see for Advantium PSA2201R: Dimensions

Contents

GE Advantium PSA2200R Technical Service Manual Manual pdf 58 page image

– 58 –TabTabStirrer Cover4. Lift the stirrer blade off the pin embedded in thecover.BladeStirrer AssemblyThe Stirrer Assembly consists of a motor, blade,and cover. The blade is motor-driven and rotateson a pin embedded in the stirrer cover. The StirrerAssembly is located at the top of the oven cavity.To remove the stirrer blade:Note: It is not necessary to remove the Stirrer Motorwhen removing the stirrer blade.1. Disconnect power from the microwave oven andopen the door.2. Remove the 2 Phillips-head screws that attachthe cover to the oven cavity.3. Lower the left side of the cover approximately1 inch, then slide it to the left and remove thecover from 2 tabs located on the right.To remove the Stirrer Motor:Note: It is not necessary to remove the stirrer bladewhen removing the Stirrer Motor.1. Remove the Air Tunnel Cover. (See Air TunnelCover.)2. Disconnect the stirrer motor wire harness.3. Remove the 2 Phillips-head screws that attachthe Stirrer Motor to the top of the oven.4. Lift the left-side of the Stirrer Motor and thenremove it from the oven.DisconnectStirrer MotorStirrer Blade HubCaution: When installing the Stirrer Motor,misalignment of the stirrer blade hub can damagethe stirrer cover. Before installing the Stirrer Motor,use a screwdriver inserted into the stirrer blade hubto pre-align the square drive of the stirrer blade toallow engagement of the motor shaft.