GE Advantium PSA2200R Technical Service Manual

Also see for Advantium PSA2201R: Dimensions

Contents

GE Advantium PSA2200R Technical Service Manual Manual pdf 41 page image

– 41 –To remove the Damper Assembly:1. Remove the Outer Cover. (See Outer Cover.)2. Remove the control panel assembly.(See Control Panel Removal.)3. Remove the latch bracket.4. Remove the Air Tunnel Inlet.(See Air Tunnel Inlet.)5. Remove the 3 Phillips-head screws holding theDamper Assembly to the Convection HeaterAssembly.Damper SwitchDamper MotorInlet Damper DoorHumidity Sensor• Location (See Top View.)• The Humidity Sensor detects the increasinghumidity released during cooking.• Problems with the Humidity Sensor will show upas "Sensor Open" on the display.Humidity Sensor TestNote:• The oven should be plugged in at least 5minutes before test.• Room temperature should not exceed 95°F.• Be sure the exterior of the cooking containerand interior of the oven are dry.• No sensor cooking is available while the ovenis hot. Wait 5 minutes after using Broil, Toast,Warm, Convection Bake, or Speedcook toallow the oven to cool enough to use sensorcooking.To test the Humidity Sensor, it is necessary toaccess the control panel. (See Control PanelAssembly.) The humidity sensor wire harness mustbe disconnected from CN8 on the power board.On the humidity sensor wire harness, check forapproximate resistance values between:Black-Red = 6.5 K Red-White = 3.25 K Black-White = 3.25 K (Continued next page)