4-40 L30 LINE CURRENT DIFFERENTIAL SYSTEM – INSTRUCTION MANUALFLEXLOGIC DESIGN AND MONITORING USING ENGINEER CHAPTER 4: INTERFACES4The following information is contained in the compile window.Figure 4-43: Compiled resultsNumber of Lines Saved — The number of compiled logic lines eliminated by using the optimization algorithm, as set in theOptimize Compiled Output option of the Preferences. In the example shown, no lines were saved because the optimizer isdisabled.FlexLogic Lines — The number of lines that the compiled logic uses, for example seven of 512 available.Virtual Output equations — The number of FlexLogic equations used in the Logic Designer window.Timers used — The number of timers used in the Logic Designer window.Memory Used — The percent of memory used in the Logic Designer window.ErrorsTable 4-3: Errors from compilingCategory Block or gateaffectedMessage DescriptionError All Number of lines (nnn) exceedsmaximum limit of 512The compiled result exceeds the limit of 512. Reduce the number ofequations to 512 or less.Error Tag-In Tag-in not configured (TAG_ID,SheetReference)A Tag-In is connected to a circuit but the Tag-In is not referencing anexisting Tag-OutError 1 Shots One Shot is over limit(SYMBOL_ID, SheetReference)The number of One-Shots contained within all of the VO blocks hasexceeded the maximum allowed for the firmware revision. This value caneither be 0 or 32.Error =VO VO has no inputs (VO_ID,SheetReference)A Virtual Output block is located within the FlexLogic diagram and thereis no block connected as input to it. Connect and identify the inputs.Error Timer Timer used more than once(TIMER_ID, SheetReference)The same timer is used in more than one place in the editor. This meanseither the circuit that the Timer belongs to has been branched, or theTimer has been duplicated.
