GE Multilin L60 Line Phase Comparison System 5-255 SETTINGS 5.2 PRODUCT SETUP5Multiple LANS, No RedundancyThe following topology provides local configuration/monitoring through EnerVista software on LAN1, to which port 1 (P1) isconnected, access to the public network on LAN2, to which port 2 (P2) is connected and communications with SCADA onLAN3, to which port 3 (P3) is connected. There is no redundancy.Figure 5–5: MULTIPLE LANS, NO REDUNDANCYd) NETWORKAs outlined in the previous section, when using more than one Ethernet port, configure each to belong to a different net-work or subnet using the IP addresses and mask.PATH: SETTINGS PRODUCT SETUP COMMUNICATIONS NETWORK 1(3) NETWORK PORT 1PRT1 IP ADDRESS:127.0.0.1Range: Standard IPV4 address formatMESSAGE PRT1 SUBNET IP MASK:255.0.0.0Range: Standard IPV4 address formatMESSAGE PRT1 GWY IP ADDRESS:0.0.0.0Range: Standard IPV4 address formatMESSAGE PRT1 GOOSE ENABLED:EnabledRange: Enabled, Disabled NETWORK PORT 2PRT2 IP ADDRESS:127.0.0.1Range: Standard IPV4 address formatMESSAGE PRT2 SUBNET IP MASK:255.0.0.0Range: Standard IPV4 address formatMESSAGE PRT2 GWY IP ADDRESS:0.0.0.0Range: Standard IPV4 address formatMESSAGE PRT2 REDUNDANCY:NoRange: No, YesMESSAGE PRT2 GOOSE ENABLED:EnabledRange: Enabled, DisabledEnerVista SoftwareML3000Public NetworkSCADAURP1IP1/MAC1P2IP2/MAC2ML3000 ML3000LAN1 LAN2LAN3P3IP3/MAC3859710A2.vsd
